peco

Below- board solanoid point motor. This unit requires a momentary contact switch and AC current to operate. Requires a rectangular hole 40mm x 2...

This is an under board mounted point motor that requires momentary AC current to operate. An extended drive pin is fitted, use the PL-9 Mounting...

This is an above board point motor that requires momantary AC currect to operate. Clips directly into a Peco 00/H0 Setrack Turnout, either Left ...

This unit enables a PL-10 Turnout Motor to be mounted on the surface of the baseboard, an optional extension arm is also included. A removable over...

Attaches directly to the PL-10 family of Turnout Motors with contact adhesive. This single pole switch can control frog polarity, ground signals et...

This fits directly to the PL-10 family of Turnout Motors. The 2 single pole changeover switches can be used to control polarity, route selection di...

This plugs directly into a ready made recess on the 0 gauge Double Slip SL-E790BH to house a PL-33 Microswitch to operate the polarity switching.

Clip this unit either side of an insulation gap on Peco H0/00 track. This can be used to isolate a loco at the end of a terminal road or siding, th...

Single Pole On/Off Switch. Use this to control features such as lighting circuits, or as a section switch where only 1 controller is used.

Single Pole On/On Switch. Use this to switch power from one device to another or for operating items such as 2 aspect colour light signals.

Provides the short burst of current required to operate the PL-11 and PL-10 series of Turnout Motors.

Provides the short burst of current required to operate the PL-11 and PL-10 series of Turnout Motors.

Provides the short burst of current required to operate the PL-11 and PL-10 series of Turnout Motors

Provides the short burst of current required to operate the PL-11 and PL-10 series of Turnout Motors.

Houses 6 PL-26 Passing Contact Switches, PL-22 On/Off Switches or PL-23 On/On Switches.

Use these when creating a diagrammatic control panel to clip fit PL-26 Passing Contact Switches, PL-22 On/Off Switches and PL-23 On/On Switches in ...

Push on Terminal Connectors and shrouds. These connectors make modification and fault finding so much easier than soldered wiring. Use them to conn...