Lighting and electrical

Below- board solanoid point motor. This unit requires a momentary contact switch and AC current to operate. Requires a rectangular hole 40mm x 2...

This is an under board mounted point motor that requires momentary AC current to operate. An extended drive pin is fitted, use the PL-9 Mounting...

This is an above board point motor that requires momantary AC currect to operate. Clips directly into a Peco 00/H0 Setrack Turnout, either Left ...

This unit enables a PL-10 Turnout Motor to be mounted on the surface of the baseboard, an optional extension arm is also included. A removable over...

Attaches directly to the PL-10 family of Turnout Motors with contact adhesive. This single pole switch can control frog polarity, ground signals et...

This fits directly to the PL-10 family of Turnout Motors. The 2 single pole changeover switches can be used to control polarity, route selection di...

This plugs directly into a ready made recess on the 0 gauge Double Slip SL-E790BH to house a PL-33 Microswitch to operate the polarity switching.

Clip this unit either side of an insulation gap on Peco H0/00 track. This can be used to isolate a loco at the end of a terminal road or siding, th...

Single Pole On/Off Switch. Use this to control features such as lighting circuits, or as a section switch where only 1 controller is used.

Single Pole On/On Switch. Use this to switch power from one device to another or for operating items such as 2 aspect colour light signals.

Provides the short burst of current required to operate the PL-11 and PL-10 series of Turnout Motors.

Provides the short burst of current required to operate the PL-11 and PL-10 series of Turnout Motors.

Provides the short burst of current required to operate the PL-11 and PL-10 series of Turnout Motors

Provides the short burst of current required to operate the PL-11 and PL-10 series of Turnout Motors.

Houses 6 PL-26 Passing Contact Switches, PL-22 On/Off Switches or PL-23 On/On Switches.

Use these when creating a diagrammatic control panel to clip fit PL-26 Passing Contact Switches, PL-22 On/Off Switches and PL-23 On/On Switches in ...

Push on Terminal Connectors and shrouds. These connectors make modification and fault finding so much easier than soldered wiring. Use them to conn...

Open type, as used on the PL-15 Twin Microswitch. Rated 16v 2amps (continuous) or 2.5amps (momentary)

Closed type, rated 16v 2amps (continuous) or 2.5amps (momentary). Use this microswitch with the PL-19 Microswitch Housing for polarity switching th...

Makes wiring the PL-10 series of Motors quick and easy. Just a simple push fit onto the motor terminals; the other ends are tinned and ready for th...

For use with all solenoid motors (e.g. PL-10 and Pl-11). Connect this unit to the 16v ac supply on your transformer. The capacitor stores up power ...

Abrasive rubber block for removing dirt and oxidisation from the rail surface. Improves running, particularly at low speeds.